Support > Technical Support

Q&A / Technical Support

Name	E-mail

Company Name

Subject

Contents
> Kevin wrote: > ------------------------------------ > Hello, I would like to establish a TCP/IP connection between my EZL-80c and a computer on a local WIFI network. The computer is connected to the WIFI network through a wired LAN and the WIFI Access Point is actually just a Linksys WIFI Router. The EZL-80c has the latest firmware, and I have successfully used the serialConfig tool to read and write WIFI environment variables (Infrastructure Mode, "linksys" SSID, channel 6 (same as router), and no WEP. However, when I plug in my Socket CF wifi card, and then apply power, nothing happens. This is true for ATC, COD, and T2S modes. I have also tried checking the DHCP box and using the start option to automatically try and connect on boot up. I have checked the STS_LED, LINK_LED, and P0 (all are HIGH) which means there is no TCP activity. Should the EZL-80c automatically obtain the IP address specified with serialConfig when it is booted up with the CF card inserted? Additionally, when I try to use ATC mode, none of my commands (ie. AT+PRIP=192.168.1.101[cr], ATZ[cr], AT+PRP=1470[cr], ATA(D)[cr]) give any response from the EZL-80c. However, I know that the TX pin on the EZL-80c is working because I get the boot up message in hyperterminal when the CF card is not inserted. I have also made sure that both the EZL-80c and my serial port are using the same configurations and speeds (8n1 and many different baud rates). Can you please give me detailed instructions/settings/commands on how to connect my EZL-80c to the computer mentioned above (assuming it is running ezTerm with port 1470 open)? Thank you. Kevin
Password	Security Code

Attachment(Image, ZIP file under 2MB)