Q&A

Your information is protected by SSL.

No. 1794	Re: Re: Re: Reset Ezl 70	2021-03-23

Dear Marco Montorsi, In order to use AT command, firstly, EZL 70 must be set to "AT Command - ATC" mode. Did you set the EZL 70's communication mode to "AT Command - ATC" mode? If not, please set it via ezConfig. And please note that the AT command should be sent via Serial Interface (COM port). It is not a TCP protocol > Marco Montorsi wrote: > ------------------------------------ > The issue was due to a bad power supply, which wasn't giving 5V but a little bit less, thank you for your response, now i have the problem to command the EZL 70, when i try to use AT command it doesn't work; First of all i create a telnet connection and the yellow led stays on, so i am sure the connection is established, from what i read i should use the command AT+PSE with final '', to switch to command state, but when i give this command in input, the EZl 70 doesn't return nothing, i can't quite understand the switch between command state and online state, Thanks, MM