bannerbar

Support > Technical Support

Q&A

Your information is protected by SSL.

No. 398	Re: Re: Re: Re: Re: problem after flash EZL50	2007-06-04

Hello! This is Sollae Systems. What do you mean? I can't understand. Please explain easily. > MIRAVETE David wrote: > ~~~~~~~~~~~~~~~~~~~~~~~~~~~ > Exists it a procedure to give the software in the EZL50L with mode ISP? > Or is this one HS? > Does Y have an address IP of help? > > David > > > Sollae Systems wrote: > > ~~~~~~~~~~~~~~~~~~~~~~~~~~~ > > Hello! This is Sollae Systems. > > > > > > Of course if you completed downloading the firmware, EZL-50L would work properly. > > But your EZL-50L would not work normally regardless of operation mode because you didn't complete downloading the firmware as you told it. > > > > > > Thank you. > > > > > > > > > MIRAVETE David wrote: > > > ~~~~~~~~~~~~~~~~~~~~~~~~~~~ > > > Hello > > > > > > The memory is correct but I have progamming only 70%. > > > The soft can't run normally. When I take this in mode ISP, I can't find the EZL with EZconfig with Mac adress or IP adress. > > > I know the latest IP but I can't ping it or take other thing. > > > It enters well in mode ISP but nothing other, that to make? > > > > > > Thanks > > > David > > > > > > > Sollae Systems wrote: > > > > ~~~~~~~~~~~~~~~~~~~~~~~~~~~ > > > > Hello! This is Sollae Systems. > > > > > > > > > > > > Although you don't complete downloading the firmware, you can flash it again. > > > > > > > > If ISP- pin is low, it means ISP operation mode, the [STS LED] have to blink rapidly. > > > > Otherwise, I'm afraid your EZL-50L has some hardware problem. > > > > > > > > I'm afraid EZL-50L doesn't support to flash via serial. Here is supported products list. > > > > EZL-200F, EZL-410, EZL-300S, EZL-400S > > > > > > > > > > > > Thank you. > > > > > > > > > MIRAVETE David wrote: > > > > > ~~~~~~~~~~~~~~~~~~~~~~~~~~~ > > > > > Hello > > > > > > > > > > I have flashing the EZL50L but my network router broke down, only 70% memory is ok. > > > > > The circuit can't work normaly: > > > > > - ISP=0, no leds are high or flashing > > > > > - ISP=1, led flashing but hotplug no work (ezconfig too) > > > > > > > > > > I'm viewing in the datasheet that i can upload by serial port but with which program? > > > > > Can flash this EZL? > > > > > > > > > > firmware newer is 1.1g, old is 1.1f > > > > > > > > > > thanks for all

Writer	Sollae Systems	Company