bannerbar

Support > Technical Support

Q&A

Your information is protected by SSL.

No. 463	Re: Re: Re: Problem esVSp with module EZL-80c v1.4f	2008-03-07

Hello. This is Sollae Systems. I've sent email to you. Thanks > Greg wrote: > ~~~~~~~~~~~~~~~~~~~~~~~~~~~ > Hello, > > Test1 : My ARP table is empty. (command arp -a). > > Test2 : I have used a different IP adresse for the module with version 1.4f and created a new virtual port with ezVSP. Same problem, the connection wifi is OK but the virtual port doesn't work. > When i run ezVSP, it's marked "Network State : not connected" while XP notify me that it's connected, signal excellent. > > Thanks. > > > > > Sollae Systems wrote: > > ~~~~~~~~~~~~~~~~~~~~~~~~~~~ > > Hello, This is Sollae Systems. > > > > You used same network information to different EZL-80c. > > It causes ARP problem. > > Because TCP/IP network use IP address and MAC address. > > > > I think it is cleared by using different IP address or delete ARP table on your PC. > > > > Thank you. > > > > > Greg wrote: > > > ~~~~~~~~~~~~~~~~~~~~~~~~~~~ > > > Hello, > > > > > > I bought 3 additional EZL-80c modules to make test.These 3 modules have the version 1.4f. > > > > > > The problem is that program ezVSP 2.2g to create > > > virtual port doesn't work any more with modules EZL-80c version 1.4f but work correctly with module EZL-80c version 1.4e. > > > > > > With ezSerialConfig 4.0k, i use the same informations (local IP, Mask, Peer IP, ezTCp Mode, ...) with module version 1.4e and modules version 1.4f. > > > But with version 1.4e, connection wifi is OK, ezVSP work correctly (my serial program work, i send/receive bytes) and with version 1.4f, connection wifi is OK but esVSP doesn't work ("not connected")(my serial program doesn't work). > > > > > > The only difference is the firmware. > > > > > > Thanks.

Writer	Sollae Systems	Company