bannerbar

Support > Technical Support

Q&A

Your information is protected by SSL.

No. 511	Re: Re: CIE-10 and Serial RS232	2009-05-29

Thanks for your answer It'ss OK now, it works : [Serial Device]-----(RS232)-----[CIE-H10]-----(LAN)------[ezVSP in PC)] is for me : [PIC 16F870]-----(RS232)-----[CIE-H10]-----(LAN)------[ezVSP in PC)] I send and receive datas from the PC with the software profilab-expert 4.0 now it'ss ok, when i launch my program (profilab-expert), i see the virtual port i created becomes active in ezVSP (9600 bauds...) and the datas are transfered from my PC to the PIC via LAN (or reverse) without problem. CIE-H10 = Nice devices ! I'sm a electronics teacher and my students will soon use it ! Stephane FRANCE (Bretagne) > Sollae Systems wrote: > ~~~~~~~~~~~~~~~~~~~~~~~~~~~ > Dear, > > I'sm sorry, but I didn'st understand you system. > > Can you explain that in detail? > > If you use the CIE-H10 as a serial device server, the system will be formed like this > > [Serial Device]-----(RS232)-----[CIE-H10]-----(LAN)------[ezVSP in PC)] > > In this system, a Port of ezVSP and CIE-H10 has to be connected on TCP/IP. > That means if the CIE-H10 is being operated as client (COD mode), ezVSP should be a TCP server. > And the peer port of CIE-H10 should be set to your PC'ss IP address. The ezManager let you do that. > > In addition, the serial port parameters (baud rate, stop bit, data bit and parity bit) which are shown on ezVSP depend on your terminal program. Please check the status of you program. > > Let me know if you can'st carry on or understand anything in above. > > And here is download links of newest version of ezVSP and ezManager. Try to use those programs. > ezVSP_3.2A > ezManager_3.1E > > > Thank you. > > Best Regards, > > > > > Stephane wrote: > > ~~~~~~~~~~~~~~~~~~~~~~~~~~~ > > Hello > > > > I try to make a communication between a CIE-H10 and a PIC (16F870) > > > > I created a virtual port and i try to send (and receive) datas from my PIC to the CIE-H10... > > > > I followed the ezVSP User'ss Manual > > ( Version 2.2c ) > > > > I use profilab-expert 4.0 > > > > My pic is configurated 9600 bauds, 8 bits > > > > CIE : Telnet, TCP Client, Remote Port 1479 > > > > Is this configuration possible ??... > > > > > > When I start (open the PORT - COM5) it indicate 115200-8-None-1 > > My PIC cannot go this speed... > > > > Can you help me please ? > > > > Thanks > > Stephane-FRANCE

Writer	Stephane	Company