Category : how to
Category : utility
You can use PC programs for setting of ezTCP. Of course, you can set the IP address of ezTCP with these programs. Following is the list of PC programs.
1. ezConfig, ezConfigMP
Management program via LAN
2. ezSerialConfig
Management program via Serial
3. ezManager
Management program via both LAN and Serial
In case of wireless LAN products, you should set the wireless LAN parameters first with ezSerialConifg or ezManager via Serial port. You can also set the IP address at same way.
* To use ezSerialConfig programs, power on ezTCP without (if it is)W-LAN card.
You could also configure IP address of ezTCP via serial port in "ATC - AT Command" communication mode.
The table below lists the possible method which sets ezTCP equipment parameters the each product especially.
| Products |
ezConfig |
ezManager |
AT Command |
ezSerialConfig |
ezConfigMP |
Telnet |
ezConfigIO |
| EZL-50 / EZL-50L / EZL-50M / EZL-60 / EZL-60L / EZL-60M / EZL-70 / EZL-200L |
Ο |
X |
Ο |
X |
X |
X |
X |
| EZL-200F |
Ο |
X |
Ο |
X |
X |
Ο |
X |
| EZL-410 / 400S |
X |
X |
Ο |
Ο |
X |
Ο |
X |
| EZL-80 / EZL-80c / EZL-90 / EZL-300L |
Ο |
X |
Ο |
X |
Ο |
X |
X |
| EZL-300S |
Ο |
X |
Ο |
X |
Ο |
Ο |
X |
| CIE-H10 / CIE-M10 / CSE-H20 / CSE-H21 / CSE-H25 / CSE-H53 / CSE-H55 / CSE-M32 / CSE-M53 / CSE-M73 / CSW-H80 / CSW-M83 / CSW-M85 |
X |
Ο |
Ο |
X |
X |
X |
X |
| EZI-10 |
X |
X |
X |
X |
X |
X |
O |
| EZI-10 |
X |
O |
X |
X |
X |
X |
X |
See also
Related Products
[ Ethernet-Module ] CSE-M53, CSE-M32, EZL-50L, EZL-50M, EZL-410
[ Ethernet-Module with RJ45 ] CSE-M73, EZL-70
[ Ethernet-Board ] EZL-60L, EZL-60M, CSE-B63
[ Ethernet-External ] CSE-H55, CSE-H53, CSE-H25, CSE-H20, CSE-H21, EZL-200L, EZL-200F, EZL-400S
[ Wireless-External ] EZL-300S, CSW-H80
[ Wireless-Module ] CSW-M85, CSW-M83
[ PPP ] EZP-250, EZU-100, CSP-H50, EZP-EVB, EZU-EVB
[ I/O ] CIE-H12, EZI-10, CIE-H12, CIE-H10, CIE-M10
