Category : how to
To connect two serial devices over Internet, two products of ezTCP are needed.
See the below diagram.
After setting values of the below parameters, connect the devices each other.
[ezTCP-A]
| Communication mode |
TCP Server
ezTCP listens to the connection request from remote clients.
|
| Local Port |
Set a Port number (ex. 1470) for receiving network packet. |
| Timeout |
0 |
[ezTCP-B]
| Communication mode |
TCP Client
ezTCP sends connection request to a server.
|
| Peer Address |
ezTCP-A's Local IP Address (IP address of the TCP Server)
|
| Peer Port |
ezTCP-A's Local Port number (TCP Server's port number)
|
| Event bytes |
0 (ezTCP sends connection request packets right after it boots up)
|
| Timeout |
0 |
See also
Related Products
[ Ethernet-Module ] CSE-M53, CSE-M32, EZL-50L, EZL-50M, EZL-410
[ Ethernet-Module with RJ45 ] CSE-M73, EZL-70
[ Ethernet-Board ] EZL-60L, EZL-60M, CSE-B63
[ Ethernet-External ] CSE-H55, CSE-H53, CSE-H25, CSE-H20, CSE-H21, EZL-200L, EZL-200F, EZL-400S
[ Wireless-External ] EZL-300S, CSW-H80
[ Wireless-Module ] CSW-M85, CSW-M83
[ PPP ] EZP-250, EZU-100, CSP-H50, EZP-EVB, EZU-EVB
[ I/O ] CIE-H10, CIE-M10
